Publication:
Microstructure formation and mechanical properties of isothermally-solidified titanium alloy joints brazed by a Ti - Zr - Cu - Ni - Be amorphous alloy foil

Дата
2020
Journal Title
Journal ISSN
Volume Title
Издатель
Научные группы
Организационные подразделения
Организационная единица
Институт ядерной физики и технологий
Цель ИЯФиТ и стратегия развития - создание и развитие научно-образовательного центра мирового уровня в области ядерной физики и технологий, радиационного материаловедения, физики элементарных частиц, астрофизики и космофизики.
Выпуск журнала
Аннотация
Two titanium alloys, OT4 and VT6-c, with a pseudo-alpha and alpha + beta structure, respectively, were brazed using transient liquid phase (TLP) bonding. To obtain high strength joints an amorphous foil (Ti - 12Zr - 22Cu - 12Ni - 1.5 Be - 0.8V wt.%) was used. Based on microstructural studies and analysis of two- and three-component phase diagrams, the mechanism of the microstructural evolution of the brazed seams of titanium alloys OT4 and VT6-c is described. Brazing at 800 oC with exposure for 0.5 h leads to the formation of a heterogeneous structure consisting of Widmanstatten, eutectoid, and eutectic. Brazed OT4 and VT6-c joints with the presence of a eutectic layer in the centre show low mechanical properties; their ultimate strength lies in a range from 200 to 550 MPa. Increasing the brazing temperature to 840 degrees C and the exposure time to 2 h, leads to the disappearance of the brittle eutectic component from the seam. This structure typically consists of Widmanstatten with a small number of eutectoid fractions. Joints with the absence of a eutectic layer in the brazed seam demonstrate a strength equal to the base titanium alloys. In this case, failure occurs in the base metal. For brazed samples from the OT4 alloy, the tensile strength value is sigma(b) = 750 +/- 3 MPa, and for samples from VT6- c, sigma(b) = 905 +/- 3 MPa.
Описание
Ключевые слова
Цитирование
Microstructure formation and mechanical properties of isothermally-solidified titanium alloy joints brazed by a Ti - Zr - Cu - Ni - Be amorphous alloy foil / Morokhov, PV [et al.] // Non-ferrous Metals. - 2020. - № 2. - P. 63-72. - 10.17580/nfm.2020.02.08
Коллекции